Epson EPL-N4000 - Upper Chute Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 207
4.2.58 Upper Chute Assembly
(See “Exit Upper Chute Assembly” on pa
g
e -279)
4.2.58.1 Removal
1. Remove the Offset Roller Assembly. (“Offset Roller Assembly” on
pa
g
e -205)
2. Disconnect P/J 133 and free the wire harness from the harness
clips.
3. Disconnect P/J 210 and free the wire harness from the harness
clips.
4. Open the Upper Chute Assembly and loosen, do not remove, the
rear screw securin
g
the Face Up Lower Chute to the frame.
5. Remove the three rear screws that secure the Lower Chute to the
frame.
6. Carefully pull the frame far enou
g
h to the rear to free the rear hin
g
e
of the Upper Chute.
7. Pull the Upper Chute to the rear and free the front hin
g
e and remove
the Upper Chute Assembly.
4.2.58.2 Installation
1. Reinstall the front hin
g
e of the Upper Chute Assembly into the
cutout at the front of the frame.
2. Carefully pull the frame far enou
g
h to the rear so you can slip the
rear hin
g
e of the Upper Chute into the cutout at the rear of the
frame.
3. Use three screws to secure the Lower Chute to the frame.
4. Open the Upper Chute Assembly and ti
g
hten the rear screw
securin
g
the Face Up Lower Chute to the frame.
5. Reconnect P/J 210 and route the wire harness under the harness
clips.
6. Reconnect P/J 133 and route the wire harness under the harness
clips.
7. Reinstall the Offset Roller Assembly. (“Offset Roller Assembly” on
pa
g
e -205)
Figure 4-73. Removal of Upper Chute Assembly