Epson EPL-N4000 - Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 179
4.2.33.2 Installation
1. Reinstall the two End Bearin
g
s onto the Shaft.
2. Reinstall the two Shaft Sprin
g
s over the End Bearin
g
s.
3. Compress the Shaft Sprin
g
s and reinstall the Shaft into the Bracket.
Make sure that the lip of each Bearin
g
is trapped behind the tabs in
the Bracket, and that each Pinch Roll lines up with the
correspondin
g
cutout in the Bracket.
4. Hook one end of each Holdin
g
Sprin
g
into a sprin
g
hole in one side
of the Bracket.
5. Brin
g
the Sprin
g
s over the Shaft and hook the other end of each
Sprin
g
into the sprin
g
hole on the opposite side of the Bracket.
6. Slide a Center Bearin
g
under each Holdin
g
Sprin
g
, as shown in the
fi
g
ure.
7. Reinstall the Pinch Roll Bracket onto the Left Middle Cover, as
shown in the fi
g
ure.
8. Reinstall the Left Middle Cover onto the printer frame.
9. Use four screws to secure the Left Middle Cover to the printer
frame.
10. Reinstall the MSI Support Assembly. (“MSI Support Assembly” on
pa
g
e -166)