Epson EPL-N4000 - Exit Drive Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 201
4.2.52 Exit Drive Assembly
(See “Exit Drive Assembly” on pa
g
e -280)
4.2.52.1 Removal
1. Remove the Offset Unit Assembly.(“Offset/Exit Assembly” on
pa
g
e -200)
2. Remove the three screws securin
g
the Exit Drive Assembly to the
Offset Unit Assembly.
3. Pull the Exit Drive Assembly strai
g
ht out and away from the Offset
Unit.
Figure 4-67. Removal of Exit Drive Assembly
4.2.52.2 Installation
1. Ali
g
n the Exit Drive Assembly with the Offset Unit Assembly so the
white drive
g
ear and shaft fit throu
g
h the correspondin
g
openin
g
in
the Exit Drive Assembly.
2. Press the Exit Drive Assembly onto the Offset Unit, sli
g
htly
repositionin
g
the Assembly so the positionin
g
pin on the upper ri
g
ht
side of the Offset Unit fits throu
g
h the correspondin
g
hole in the Exit
Drive Assembly. Make sure you do not trap any wire harnesses
between the Exit Drive Assembly and the Offset Unit Assembly.
3. Use three screws to secure the Exit Drive Assembly to the Offset
Unit Assembly.
4. Reinstall the Offset Unit Assembly. (“Offset/Exit Assembly” on
pa
g
e -200)