Epson EPL-N4000 - Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 171
4.2.26.2 Installation
1. Position the MSI Feed Clutch with the
g
ear facin
g
out, and slide the
Clutch onto the Feed Shaft.
2. Thread the Clutch wire harness throu
g
h the cutout in the Support
frame.
3. Rotate the Clutch so the notch in the Clutch fits into the key in the
Assembly (Fi
g
ure on the previous pa
g
e).
4. Use and E-rin
g
to secure the MSI Feed Clutch to the Feed Shaft.
5. Reinstall the Link Sprin
g
onto the Rear Latch (Fi
g
ure on the
previous pa
g
e).
6. Slide the MSI Link Gear, alon
g
with the MSI Drive Gear Assembly,
onto the idler shaft.
7. Use an E-rin
g
to secure the MSI Link Gear to the idler shaft.
8. Reinstall the Rear Hook Bracket to the Feeder Assembly, and use
one screw to secure the Bracket.
9. Reconnect J208.
10. Reinstall the MSI Tray Support and use a screw to secure it to the
Feeder Assembly.
11. Reinstall the MSI Tray Assembly. (“MSI Tray Assembly” on
pa
g
e -164)