EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 159
4.2.18 Tray 2 Feed Clutch
(See “Paper Pick Up-Tray 2” on pa
e -262)
4.2.18.1 Removal
1. Remove the Rear Cover 1TM. (See “Rear Cover 1TM” on
pa
e -143)
2. Disconnect J240 from the Feed Clutch.
3. Remove the E rin
the Clutch to the shaft, and slide the
Clutch off of the shaft.
4. Remove the E rin
the Gear to the shaft, and slide the
Gear and Bearin
off of the shaft.
4.2.18.2 Installation
1. Slide the Bearin
onto the shaft, and seat it in the cutout in the
printer frame.
2. Slide the Gear onto the shaft, and use an E rin
to secure it to the
shaft.
3. Slide the Feed Clutch onto the shaft, makin
notch on the shaft hooks onto the tab on the frame.
4. Use an E rin
to secure the Clutch to the shaft.
5. Reconnect J240 to the Feed Clutch.
6. Reinstall the Rear Cover 1TM. (“Rear Cover 1TM” on pa
e -143)
Figure 4-28. Removal of Tray2 Feed Clutch
To Next Page
Loading...
