EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 26
1.4.1.1 Status Sheet
En
ine Status Sheet is prepared and Jam Counter is not printed.
Hardware confi
uration
Mounted memory for installed memory
The memory size obtained by subtractin
ram code size from
the mounted memory is stated for Available Memory. The followin
ends indicate the fact that options are fitted.
RAM DIMM: Added to Installed Memory, Available memory
Type-B I/F: “AUX” is added to “Installed Interface”.
Lar
e Capacity Paper Unit: “Lower Cassette 3, Lower Cassette 4,
Lower Cassette 5” is added to “Other
Options”.
ENV Tray: “ENV Tray” is added to “Other Options”.
Face-up Tray: When Face-up Enable of Setup Menu = On, “Face-
up Tray” is added to “Other Options”.
Duplex Unit: “Duplex Unit” is added to “Other Options”.
Multibin: “Multibin” is added to “Other Options”.
Finisher: “Finisher Stapler” is added to “Other Options”.
HDD: “Hard Disk XGB” is added to “Other Options”.
NLSP Font ROM: The option product name is added to “Other
Options”.
Font/Macro ROM: The option product name is added to “Other
Options”.
When Adobe PS 3 kit is installed: “Adobe PS 3 kit Menu, Error
Sheet” is added to “Default Settin
s” “Adobe PostScript3” is added
to “Installed Emulation” “Version of Adobe PS 3 kit” is added to
“Firmware Revision”.
NOTE:For EPL-N4000, Finisher and HDD cannot be installed.
1.4.2 Panel Setting Mode
Here explains panel settin
mode which sets various function of the
printer.
1.4.2.1 One Touch Setting Mode
By pressin
Select Type(ALT) switch on the control panel, the printer
enters to the one-touch settin
oes to the one-touch set-
tin
mode are mentioned below.
Table 1-27. One touch setting modes
Mode/Switch Setting Menu Setting Item Setting Value Enter
One touch
settin
e size Minification Orientation
One touch
settin
mode2
Printer mode Copies MP tra
To Next Page
Loading...
