Epson EPL-N4000 - Face up Exit Sensor; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 204
4.2.55 Face Up Exit Sensor
(See “Exit Lower Chute” on pa
g
e -277)
4.2.55.1 Removal
1. Remove the Fuser Full Cover. (“Fuser Full Cover” on pa
g
e -138)
2. Disconnect J109.
3. Remove the two screws securin
g
the Face Up Exit Sensor to the
Exit Sensor Bracket and remove the Sensor.
4. Remove the two screws securin
g
the Exit Sensor Bracket to the
Lower Chute, and remove the Bracket.
5. Unhook the Exit Sensor Sprin
g
from the Bracket, and remove the
Exit Sensor Actuator.
4.2.55.2 Installation
1. Reinstall the Exit Sensor Actuator onto Exit Sensor Bracket.
2. Hook the Exit Sensor Sprin
g
onto the Bracket.
3. Reinstall the Bracket onto the Lower Chute, and use two screws to
secure the Bracket.
4. Reinstall the Face Up Exit Sensor onto the Bracket, and use two
screws to secure the Sensor.
5. Reconnect J109.
6. Reinstall the Fuser Full Cover. (“Fuser Full Cover” on pa
g
e -138)
Figure 4-70. Removal of Face Up Exit Sensor