Epson EPL-N4000 - Registration Chute Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 188
4.2.41 Registration Chute Assembly
(See “Re
g
istration” on pa
g
e -271)
4.2.41.1 Removal
1. Remove the Left Upper Cover Assembly. (“Left Upper Cover
Assembly” on pa
g
e -185)
2. Remove the Re
g
istration Clutch.(“Re
g
istration Clutch” on
pa
g
e -184)
3. Remove the screw securin
g
the Inner Cover to the printer frame,
and remove the Inner Cover.
4. Remove the EP Cartrid
g
e. (“EP Cartrid
g
e (Toner Cartrid
g
e)” on
pa
g
e -192)
5. Remove the screw securin
g
the Ma
g
net Plate to the printer frame,
and remove the Plate.
6. Remove the two screws (under the Ma
g
net Plate) securin
g
the front
of the Re
g
istration Chute to the printer frame.
7. Remove the two screws (under the Re
g
istration Clutch) securin
g
the rear of the Re
g
istration Chute to the printer frame, and remove
the Chute.
8. Disconnect P/J103 from the Re
g
istration Sensor.
4.2.41.2 Installation
1. Reconnect P/J103 to the Re
g
istration Sensor.
2. Reinstall the Re
g
istration Chute Assembly into the printer
frame.Make sure the mylar strip is on the outside of the Chute.
3. Ali
g
n the four screw holes (two at each end) in the Re
g
istration
Chute with the four screw holes in the printer frame.
4. Use two screws to secure the Chute to the front of the frame, and
use two screws to secure the Chute to the rear of the frame.
5. Reinstall the Ma
g
net Plate to the printer frame, and use one screw
to secure the Plate.
6. Reinstall the Inner Cover to the frame, and use one screw to secure
the Cover.
7. Reinstall the Left Upper Cover Assembly.
8. Reinstall the Re
g
istration Clutch. (“Left Upper Cover Assembly” on
pa
g
e -185)
9. Reinstall the EP Cartrid
g
e. (“EP Cartrid
g
e (Toner Cartrid
g
e)” on
pa
g
e -192)
Figure 4-56. Removal of Registration Chute Assembly