EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 36
The paper type to be specified in paper feed selection is
specified by the PCL5 command and ESC/Pa
e command only.
In a printer mode without such specification, the same operation
as when Plain is specified is performed.
No “Paper Type settin
s are made on EPL-N4000. However, if
the paper type settin
s (MP Type, LC1 to LC5 Type) are
“Trnsprncy” and “Prepunched”, the settin
ine is informed of cardboard for
temperature control. (TBD)
TRAY MENU/MP MODE
When trays are not specified by command, EJL, PJL, etc., MP
Tray’s paper feed selection is prioritized. If the settin
is
“Normal” (factory default settin
), MP Tray’s paper feed
selection is
hest priority (the same as the existin
is “Last”, MP Tray’s paper feed selection
is
iven the lowest priority.
Normal: MP Tray>LC1>......
Last: LC1>LC2>...>MP Tray
This settin
becomes valid after a warm boot.
1.4.2.4 Printing Menu
PRINTING MENU/OUT BIN
Out Bin items which can be selected in accordance with the settin
s of
Face-up Enable, Multibin and Finisher in the Set Up Menu are as
follows.
Table 1-39.
Table 1-40.
If Stacker is selected when the Multibin settin
is Stacker, the 1500-
sheet lar
e-capacity eject unit will be assumed. Paper ejection be
ins
with Multibin 10. When Multibin 1 becomes full, paper is ejected to
Face-down. From EPL-N4000+, switchin
to Face-down is disabled if
“Stacker=No Face-down”.
If Sorter is selected when the Multibin settin
Multibin
(Not
installed)
Mailbox Sorter MultiSort Stacker
Face-up
Enable
Off Face-down Face-
down,
Mailbox1 -
10
Face-
down,
Sorter
Face-
down,
Sorter
Face-down,
Stacker
On Face down,
Face-up
Face-
down,
Face-up
Mailbox1-
10
Face-
down,
Face-up,
Sorter
Face-
down,
Face-up,
Sorter
Face-down,
Face-up,
Stacker
Finisher
(Not installed) Stacker
Face-up Enable Off Face-down Face-down, Stacker
On Face-down, Face-up Face-down, Face-up,
Stacker