EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 184
4.2.38 Registration Clutch
(See “Re
e -271)
4.2.38.1 Removal
1. Remove the Rear Cover. (“Rear Cover Assembly” on pa
e -140)
2. Disconnect P/J 200 from the Re
istration Clutch.
3. Remove the E clip securin
istration Clutch to the
Re
istration Shaft.
4. Push out on the shaft latch as you slide the Clutch off of the shaft.
Figure 4-53. Removal of Registration Clutch
4.2.38.2 Installation
1. Slide the Re
istration Clutch onto the shaft. The shaft latch snaps
the Clutch into place on the shaft.
2. Use an E clip to secure the Re
istration Clutch to the Re
istration
Shaft.
3. Reconnect P/J 200 from the Re
istration Clutch.
4. Reinstall the Rear Cover. (“Rear Cover Assembly” on pa
To Next Page
Loading...
