Epson EPL-N4000 - Offset Motor; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 203
4.2.54 Offset Motor
(See “Exit Lower Chute” on pa
g
e -277)
4.2.54.1 Removal
1. Remove the Fuser Full Cover. (“Fuser Full Cover” on pa
g
e -138)
2. Remove the two screws securin
g
the Motor to the Offset Assembly.
3. Lift the Motor off of the Assembly and free the Motor arm from the
Offset Roll Rack.
4. Disconnect J209 from the Offset Motor.
Figure 4-69. Removal of Offset Motor
4.2.54.2 Installation
1. Insert the Motor arm into the Offset Roll Rack.
2. Reconnect J209 to the Offset Motor.
3. Reinstall the Offset Motor onto the Offset Assembly.
4. Use two screws to secure the Motor to the Assembly.
5. Reinstall the Fuser Full Cover. (“Fuser Full Cover” on pa
g
e -138)