Epson EPL-N4000 - Registration Sensor; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 190
4.2.43 Registration Sensor
(See “Re
g
istration” on pa
g
e -271)
4.2.43.1 Installation
1. Open the Left Upper Cover.
2. Squeeze in all four Sensor latches while you pull the Sensor out of
the Re
g
istration Chute Assembly.
3. Disconnect J103 from the rear of the Sensor.
Figure 4-58. Removal of Registration Sensor
4.2.43.2 Installation
1. Reconnect J103 to the Re
g
istration Sensor.
2. Insert the Sensor into the cutout in the Re
g
istration Chute
Assembly.
3. Press in on the Sensor unit it snaps into place.
4. Close the Left Upper Cover.