Epson EPL-N4000 - Offset Roller Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 205
4.2.56 Offset Roller Assembly
(See “Offset Roller” on pa
g
e -278)
4.2.56.1 Removal
1. Remove the Offset Drive Assembly. (“Exit Drive Assembly” on
pa
g
e -201)
2. Remove the Offset Motor. (“Offset Motor” on pa
g
e -203)
3. Remove the Face Up Exit Sensor. (“Face Up Exit Sensor” on
pa
g
e -204)
4. Remove the Gear located at the end of the Roller Assembly.
5. Remove the K clip securin
g
the Roller shaft to the rear bearin
g
.
6. Slide the bearin
g
out of the Offset Assembly frame.
7. Slide the front bearin
g
out the Assembly frame, and remove the
Offset Roller Assembly.
4.2.56.2 Installation
1. Slide the rear of the Roller shaft throu
g
h the rear bearin
g
cutout in
the Assembly frame.
2. Insert the front bearin
g
, still attached to the front of the shaft, into the
front bearin
g
cutout in the Assembly frame.
3. Use a K clip to secure the shaft to the rear bearin
g
.
4. Reinstall the Gear onto the rear of the shaft. The Gear snaps into
place.
5. Reinstall the Face Up Exit Sensor. (“Face Up Exit Sensor” on
pa
g
e -204)
6. Reinstall the Offset Motor. (“Offset Roller Assembly” on pa
g
e -205)
7. Reinstall the Offset Drive Assembly. (“Exit Drive Assembly” on
pa
g
e -201)
Figure 4-71. Removal of Offset Roller Assembly