EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 146
4.2.9 Feed, Nudger, and Retard Rolls
(See “Paper Pick Up - Tray 1” on pa
e -259 and “Retard and Take
Away- Tray 2” on pa
e -263)
4.2.9.1 Removal
1. Remove the paper tray from the appropriate feeder.
2. Press in on the front of the Chute, and remove the Chute.
3. Pull out on the Roll latch and slide the Roll off of the shaft.
4. Repeat step 3 for the remainin
two Rolls.
4.2.9.2 Installation
1. Position the Roll with the latch end facin
out, and slide the Roll
onto the shaft.
2. Rotate and push the Roll down the shaft until the latch locks the Roll
into place.
3. Repeat steps 1 and 2 for the remainin
two Rolls.
4. Reinstall the Chute by slidin
in the rear of the Chute
into the tab on the frame, then sli
the tab at the front of the Chute into the openin
on the
frame.
5. Reinstall the paper tray.
6. Reset the Paper Feeder Usa
for the feeder with the new
Rolls.
Figure 4-16. Removal of Feed, Nudger&Retard Rolls
CHECK
POINT
Use this procedure for Feeders1 and Feeders 2.
Replace the Feeder, Nudger, and Retard Rolls as a
unit.
If Feed Roll is exchanged, be sure to perform
LC1
∼
5 Counter Clear. (See “Panel Setting Mode”
on page -26 and “Maintenance Mode” on
page -46)
To Next Page
Loading...
