EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 189
4.2.42 Registration Roll Assembly
(See “Re
e -271)
4.2.42.1 Removal
1. Remove the Re
istration Chute Assembly. (“Re
istration Chute
Assembly” on pa
e -188)
2. Remove the E rin
istration Roll Shaft.
3. Slide the Shaft to the rear to free the front of the Shaft from the front
bearin
istration Roll Assembly.
4.2.42.2 Installation
1. Make sure both the front and rear bearin
s are in place in the frame.
2. Slide the rear of the Re
istration Roll Shaft throu
.
3. Slide the front of the Shaft to the front bearin
to secure the rear of the Shaft to the rear bearin
istration Chute Assembly. (“Re
istration Chute
Assembly” on pa
e -188)
Figure 4-57. Removal of Registration Roll Assembly
To Next Page
Loading...
