Epson EPL-N4000 - Rear Cover Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 140
4.2.3 Rear Cover Assembly
(See “Rear, Left and Ri
g
ht Cover” on pa
g
e -255)
4.2.3.1 Removal
1. Remove the AC power cord from the rear of the printer.
2. Remove the two screws securin
g
the Rear Cover Assembly to the
printer frame.
3. Pull the bottom of the Rear Cover away from the printer frame and
slide the Cover down to remove it.
4.2.3.2 Installation
1. Slide the top ed
g
e of the Rear Cover under the ed
g
e of the Top
Cover, then press the Rear Cover a
g
ainst the printer frame.
2. Slide the Cover down so the bottom ed
g
e catches the lip of the
printer frame.
3. Use two screws to secure the Rear Cover Assembly to the printer
frame.
4. Reconnect the AC power cord to the rear of the printer.
Figure 4-10. Removal of Rear Cover Assembly