Epson EPL-N4000 - Features

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 2
1.1 Features
EPL-N4000/N4000+ is non-impact pa
g
e printer applied with laser xero-
g
raphic method.
Figure 1-1. Exterior View of EPL-N4000+
ENGINE FEATURES

Hi
g
h speed & hi
g
h reliability A3 en
g
ine.

Resolution:600 dpi

Printin
g
speed:40 ppm (A4) / 40ppm (Letter)

Standard paper feeders are two universal cassettes (500 sheets x2)
and manual feed tray (50 sheets)

Options: lar
g
e-capacity paper unit (500 sheets(A4 to A3) on MP tray
+ 1000 sheets on cassette 1 + 1000 sheets (A4, Letter, and
Executive sizes) on cassette 2)
Refer to Table 1-6, “Feedin
g
Method,” on pa
g
e 10 for details.

Offset stackin
g
equipped as standard

Wide ran
g
e of options (Duplex Module, Face-up tray, Envelope
Feeder, Multibin Unit, Finisher Stapler*, HDD*)
NOTE:Finisher Stapler and HDD are only supported from
EPL-N4000+. Refer to Table 1-2 on page 4 for support
range.
CONTROLLER FEATURES

Hi
g
h speed controller, employin
g
new CPU
64-bit RISC CPU VR4700 133MHz

SDRAM DIMMs adopted
64MB RAM equipped as standard
Expandable up to 256 MB (usin
g
commercially available SDRAM
DIMMs) However, 256MB SDRAM DIMMs cannot be used.

Two standard interfaces
IEEE 1284 parallel interface
Ethernet interface (100Base-TX)

1 slot for Type B interface
Type B Level 3 is supported from EPL-N4000+.

Enhanced Micro Gray loaded