EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 3
SOFTWARE FEATURES
Supported emulation
PCL5e Enhanced Micro Gray support, paper
handlin
support
PostScript Level3*
1
Refer to the Adobe PS 3 kit specification
ESC/Pa
e Enhanced Micro Gray support, paper
handlin
e has
upward compatibility compared to
EPL-N4000.
FX, ESC/P2,1239X Paper handlin
support
PJL, EJL
RCC Firmware updatin
ine. Not open to users.
EpsonNet WebAssist Enables to set printer confi
lish version is
available and Internet Explorer 4.01 or
above is necessary.
NOTE:*
1
PostScript Level3 is optional. To be installed in slot A or B.
Dedicated to EPL-N4000. Adobe PS 3 kit needs to be
updated to
EPL-N4000+, too.
Rewritin
flash ROM DIMMs
Flash ROM DIMMs in slot A and the pro
ram slot can be rewritten
from any I/F. (Not open to users except slot A.)
Downloadin
h slot A and inserted in slot C
when used. When rewritin
the firmware of Adobe PS 3 kit for EPL-
N4000 to Adobe PS 3 kit for EPL-N4000+, insert in slot A.
Panel Settin
EPL-N4000:
Available to set the printer mode, print menu and device menu
individually by each lan
e’s environment interface
EPL-N4000+:
All modes except the printer mode are chan
ed to the common
environment with interface.
Environment settin
not by the panel operation is added
Table 1-1. Printer environment setting not by the panel setting
NOTE:“O” = Available
“--” = Not available
Support ran
e of EPL-N4000 and EPL-N4000+
For this product, firmware will be developed in two sta
es, EPL-
N4000 and EPL-N4000+. Firmware is stored in the flash ROM
DIMM, and therefore it can be modified from EPL-N4000 to EPL-
N4000+. Each support ran
e is as follows: The hardware is
common.
Firmware
Adobe PS 3 kit
module
Print Finisher, HDD
EPL-N4000 EPL-N400 enable disable
EPL-N4000 EPL-N4000+ enable disable
EPL-N4000+ EPL-N4000
disable
(invalid Adobe PS
3 kit error)
disable
EPL-N4000+ EPL-N4000+ enable enable
EPL-N4000 EPL-N4000+
Panel settin