EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 174
4.2.29 MSI Nudger Roll Assembly
(See “MSI Tray Assembly” on pa
e -268)
4.2.29.1 Removal
1. Remove the MSI Feed Clutch. (“MSI Feed Clutch” on pa
e -169)
2. Remove MSI Feed Roll. (“MSI Feed Roll” on pa
e -172)
3. Remove the E-rin
the MSI Front Feed Bearin
to the
Feed Shaft, and remove the Bearin
.
4. Slide the Feed Shaft out of the Nud
er Roll Assembly, and remove
the Assembly from the MSI Feeder frame.
5. Remove the Front and Rear Feed Bearin
er Roll
Assembly.
Figure 4-43. Removal of MSI Nudger Roll Assembly
4.2.29.2 Installation
1. Reinstall the Front and Rear Feed Bearin
er Roll
Assembly (see the fi
ure for correct placement).
2. Hook one end of the Feed Sprin
er Roll Assembly
frame.
3. Reinstall the Nud
er Roll Assembly into the MSI Feeder Assembly.
4. Hold the Feed Gear in place, with the flat side a
er
Roll Assembly.
5. Slide the Feed Shaft throu
h the cutout
for the Front Feed Bearin
.
6. Slip the Front Feed Bearin
over the end of the Feed Shaft, and
slide the Bearin
into the cutout in the frame.
7. Continue slidin
the Feed Shaft as far as it will
to secure the Shaft to the Front Feed Bearin
.
9. Hook the free end of the Feed Sprin
at the
rear of the Assembly frame.
10. Reinstall the MSI Feed Roll. (“MSI Feed Roll” on pa
e -172)
11. Reinstall the MSI Feed Clutch. (“MSI Feed Clutch” on pa
To Next Page
Loading...
