Epson EPL-N4000 - MSI Support Assembly; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 166
4.2.24 MSI Support Assembly
(See “Multi Sheet Inserter and MSI/Duplex Support” on pa
g
e -265)
4.2.24.1 Removal
1. Remove the MSI Feeder Assembly. (“MSI Feeder Assembly
(Manual Feeder)” on pa
g
e -164)
2. Remove the one screw securin
g
the Front Support Cover to the
Support Assembly, and remove the Cover.
3. Remove the one screw securin
g
the Rear Support Cover to the
Support Assembly, and remove the Cover.
4. Remove the Rear Cover Assembly. (“Rear Cover Assembly” on
pa
g
e -140)
5. Disconnect J603.
6. Remove the four screws securin
g
the MSI Support Assembly to the
printer frame, and remove the Assembly.
4.2.24.2 Installation
1. Position the MSI Support Assembly a few inches from the printer
frame.
2. Insert the wire harness into the cutout in the printer frame.
3. Slide the two positionin
g
pins that are located at both ends of the
Support Assembly into the holes in the frame.
4. Use four screws to secure the Assembly to the frame.
5. Reconnect J603.
6. Reinstall the Rear Cover Assembly. “Rear Cover Assembly” on
pa
g
e -140)
7. Reinstall the Rear Support Cover and use one screw to secure it to
the Support Assembly.
8. Reinstall the Front Support Cover and use one screw to secure it to
the Support Assembly.
9. Reinstall the MSI Feeder Assembly. (“MSI Feeder Assembly
(Manual Feeder)” on pa
g
e -164)
Figure 4-35. Removal of MSI Support Assembly