Epson EPL-N4000 - Reliability, Durability and Maintainability

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 13

Transient Outa
g
e: DIP 100% (at rated volta
g
e-100%) 1 cycle

Electrostatic Tolerance: Less than
±
8KV
No dama
g
e to ima
g
e

Sur
g
e Current: 1/2-cycle / Not above 100A

Insulation Resistance(TBD): Less than 10 M
Ω

Dielectric Stren
g
th: Insulation shall not break down when
the followin
g
volta
g
e is applied between
primary circuit and chassis for 1 minute.
Table 1-10. Dielectric strength

Leaka
g
e Current: 120V 3.5 mA or less
200V series 3.5 mA or less
1.3.5 Reliability, Durability and Maintainability

MPBF: 400,000 pa
g
es (one-side printin
g
)

Print Volume: Maximum 150,000 pa
g
es/month
Avera
g
e 25,000 pa
g
es/month
Table 1-11. Paper Feed Reliability
NOTE:a. These figures are measured, assuming normal paper is
used. This measurement does not apply when boundary
face is generated. Boundary face is generated when the
additional paper is added to paper already set.

Printin
g
position reliability
Table 1-12. Printing position

Skew (See the fi
g
ure on next pa
g
e)
Table 1-13. Skew
NOTE: The measurements for MP Tray are based on one-side
printing.
Primary-Chassis Primary- Secondary
100/120V AC1000V AC2000V
200 V Series AC1500V AC3000V
Paper Jam Rate
a
Double Feed Rate
Standard
Environment
Average of all
environment
Standard
Environment
Average of all
environment
MP Tra
y
1/200 1/100 1/100 TBD
Cassette1, 2 1/5000 1/2500 1/5000 1/2500
Hi
g
h capacit
y
feeder, Cassette
1/5000 1/2500 1/5000 1/2500
One-side printing duplex printing MP Tray*
Main Scan direction
±
2.0mm
±
2.4mm
±
2.9mm
Sub scan direction
±
1.5mm
±
1.9mm
±
2.1mm
One-side printing duplex printing MP Tray*
Main scan direction (
|
c-d
|
)
±
2.0mm
±
2.4mm
±
2.9mm
Sub scan direction (
|
a-b
|
)
±
1.5mm
±
1.9mm
±
2.1mm