Epson EPL-N4000 - Page 38

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 24

Form Feed:If Data li
g
ht is On in the not-ready condition, the
printer prints the received data on the one sheet by
pressin
g
this button. If the plural numbers of printin
g
is
selected, the printer prints out that number.
In case of the data which the control code has not
ended yet, the printer prints out the data, which has
already received.
NOTE:However, if the data light is off, the printer does not eject the
paper.

Continue: Error is canceled by pressin
g
this button, while the
Continue LED li
g
ht is on. When warnin
g
occurs,
warnin
g
indication is canceled by pressin
g
this button.

Select type/Alt switch:Ordinary condition, One-touch settin
g
mode1,
2 and select type mode.

Menu switch: The printer
g
oes to the settin
g
mode by
pressin
g
this switch.

Item switch: The printer
g
oes to the previous settin
g
item
by pressin
g
this switch.

Value selection switch:The printer
g
oes to the previous settin
g
item
by pressin
g
this switch.

Enter switch: By pressin
g
this button, the printer
g
oes to
status sheet in the test printin
g
menu.

Reset(Continue): The printer stops printin
g
or resets by
pressin
g
Alt and Continue switches. After
displayin
g
“Reset” on the display, pressin
g
both switches for 5 seconds lead to “Reset
All” and executes warm boot.
Each switch operation for the panel settin
g
is on the next pa
g
e.
CAUTION

This printer has EEPROM and hard disk drive HDD
(option) inside and records various setting values
and printing data. If the printer is turned off during
this process, writing operation is not guaranteed, and
error occurs when the printer is turned on next time.
Therefore, never turn off the printer at the following
cases;
•
From the power on to On-line light on.
•
On-line light is blinking
•
When the printer is printing(when the paper
transporting motor is in active)

When you want to stop printing, press “On-line
switch” or perform Job Cancel/Reset.