EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 28
Table 1-29. Printer Setting
NOTE:*1: Appears only when the MP tray is installed, and can then be
selected. The MP tray does not support the envelope size to
which the ENV tray corresponds.
*2: An error will result if neither MP tray nor ENV tray is installed.
Therefore, either tray is always present in a normal state.
*3:Appears only when the ENV tray is installed, and can then be
selected.
*4: Appears only when the Large Capacity Paper Unit is
installed, and can then be selected.
*5: Factory default setting when the A4/LT configuration is A4.
*6:Factory default setting when the A4/LT configuration is LT.
*7: CTM size:min. 100 x 139.7mm, max. 297 x 431.8 mm
*8: Appears only when Face-up Enable=On is set, and can then
be selected .
:*9: Appears only when the multibin unit is installed and the
printer is in Stacker mode and Finisher Stapler is installed, and
can then be selected.
*10: Appears only when the multibin unit is installed and the
printer is in Mailbox mode, and can then be selected.
*11: Appears only when the multibin unit is installed and the
printer is in Sorter or MultiSort mode; can then be selected.
*12: Not displayed on the panel. Not printed on the status sheet.
Can be set with EJL, PJL and so forth. Not saved in NVRAM.
*13: Only LJ4 mode and ESC/Page mode are valid.
*14: Appears only when the optional duplex unit is installed.
*15: Appears when the finisher is installed.
*16:Appears when the optional Duplex Unit or the Finisher
Staple is installed.
Menu Item Value
Printin