EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 39
PRINTING MENU/OFFSET STACKING
Specify whether to perform Offset Stackin
paper to a
paper eject unit with a shifter. This settin
is for all the paper eject units
and consequently, it is the settin
item valid for Face-down and Finisher
with a shifter on the EPL-N4000.
When Multibin = Stacker and Out Bin = Stacker, Offset Stackin
becomes invalid and paper is ejected to the center even if the bins to
bin1 become full and Face-down switches to.
Where print jobs with Offset Stackin
= On and Off are mixed, the paper
eject position does not move at a boundary when jobs with Offset
Stackin
= Off are successive but the paper eject position moves at the
boundary if either precedin
print job has Offset Stackin
is not executed as requested due to reset processin
or
the occurence of a “Colla
, the paper eject
position may be shifted.
If one job or quantity contains pa
= On and Off,
the specification for the first pa
e to be output to a paper eject with a
shifter only becomes valid.
Limitations on Offset Stackin
s are MON, C10, DL, C5 and CTM or
the Type Settin
s are Trnsprncy, Label and Prepunched, Offset
Stackin
becomes invalid and paper is ejected to the center. This is
the same as when Size or Type of the paper fed unit are those
aforementioned.
PRINTING MENU / STAPLE
Desi
Double: Central double staplin
0
PRINTING MENU / STAPLE POSITION
Desi
nate the staple position as a lo
ic position
L: Left-hand side
R: Ri
ht-hand side (used for ri
in Japan. This is
not used in forei
n countries)
GENERAL EXPLANATION OF STAPLE DESIGNATION
If the paper eject destination is not Stacker, desi
nored
and paper is ejected to the specified paper eject destination. No
error occurs.
If the finisher option is not present, desi
nored. No error
occurs.
If the paper size cannot be sent to the finisher, desi
“Outbin Select Error”)
If the paper size or type that can be sent to the finisher but cannot
be stapled is desi
nored and paper is
ejected. (TBD. There are no applicable size and type under the
present circumstances)
If an attempt is made to staple different-size paper, or to chan
e the
output bin to other than the Stacker durin
one job, paper is ejected
from the compile tray without staplin
“Can’t Staple”)
No recovery is an erroneous staplin
“Check
Stapler” occurs.
If an attempt is made to print with staple desi
nation when there is
no staple, the error “Staple Supply” occurs.
If an attempt is made to staple one sheet, paper is ejected from the
compile tray without staplin
To Next Page
Loading...
