Maintenance 2. General Maintenance
98 N6 Rev.2
The Manipulator operation hours can be checked in [Controller Status Viewer] dialog
-[Motor On Hours].
(1) Select EPSON RC+ menu-[Tools]-[Controller] to open the [Controller Tools] dialog
box.
(2) Click the <View Controller Status> button to open the [Browse For Folder] dialog.
(3) Select the folder where the information is stored.
(4) Click <OK> to view the [Controller Status Viewer] dialog.
(5) Select [Robot] from the tree menu on the left side.
For the parts subject to overhaul, refer to Maintenance 9. Maintenance Parts List.
For details of replacement of each part, refer to the Maintenance section.
Please contact the distributor of your region for further information.
To Next Page
Loading...
