Epson N6 Series - Joint #1 Inside Cover; N6-A1000** (Joint #1 Inside Cover)

Maintenance 3. Covers
120 N6 Rev.2
3.3 Joint #1 Inside Cover
3.3.1 N6-A1000** (Joint #1 Inside Cover)
Removal
Remove the screws, and then remove the Joint #1
in
side cover.
Cross recessed binding head machine screw:
3-M4×8
Installation
Set
the Joint #1 inside cover to the Manipulator and
fix it with the screws.
Cross recessed binding head machine screw:
3-M4×8
Tightening torque: 0.45±0.05 N·m
The cover may get broken if it is
fastened too tight.
B
e careful not to exceed the above tightening torque.

NOTE