Maintenance 3. Covers
N6 Rev.2 143
the Joint #4 inside cover and the Joint #4 outside cover, and set them to the
. Then, fix them with the screws.
Cross recessed binding head machine screw: 4-M4×8
Tightening torque: 0.45 ± 0.05 N·m
The cover may get broken if it is
fastened too tight.
e careful not to exceed the above tightening torque.
tighten the screws when the covers are not matched properly.
The covers may get broken.
Be careful not to get the cables caught in the cover.
To Next Page
Loading...
