Epson N6 Series - Page 220

Maintenance 4. Cable
208 N6 Rev.2
The
subsequent steps are described with the standard model’s cable unit.
For cleanroom model, a yellow air tube is included in the cable unit.
Installation
Cable Unit
(N6
-A850*R)
Cable direction:
Standard
(backward)
(1)
Check the cable unit.
The cable unit consists of the
cable A and the cable B.
A: Include the gray colored cable.
B: Include the ground wire (green).
T
he cable A and the cable B are bundled by eight cable ties.
Standard model
Cleanroom model
Base side
End effector side
Base side
End effector side
Hereinafter referred to as below in order from the base side.
A1, A2, …, A8 (cable A)
B1, B2, …, B8 (cable B)
Do not
cut off or move the position of the cable tie. The cable unit will not be able
to install properly.
(2)
Fix the cable unit to the cable fixing plate.
Be careful for the following:
Cable ties (AB200) × 4 (1 to 4)
Tightening strength: 85 ± 5 N
Base side
Front
A
B
C
able A
Set the A1 of the cable tie to the cable
fixing plate and fix it by using the cable
ties 1 and 2. Make sure that the gray
colored cable is on the plate side.
C
able B
Set the B1 of the cable tie to the cable
fixing
plate and fix it by using the cable
ties 3 and 4. Make sure that the two air
tubes (blue and white) are on the opposite
side of the plate.
Base side
Back
A
B
B1
A1
3
1
2
4

NOTE

NOTE