Maintenance 6. Battery
324 N6 Rev.2
The battery may run out if it passes the recommended replacement time.
If no warnings of voltage reduction occur, calibration for all joints is not necessary. You
need to perform calibration if the position moves from the originals after replaced the
battery.
Always use the lithium metal battery and battery board designated by us.
Be careful of the battery polarity to connect it correctly.
N6-A1000**
N6-A850**R
Maintenance
2172925 (2 lithium metal batteries for replacement)
Cross-point screwdriver (#2)
For cross recessed head screws
To Next Page
Loading...
