Epson N6 Series

N6 Rev.2 v
Before Reading This Manual
This section describes what you should know before reading this manual.
Structure of Control System
N6 Manipulators can be used with the following combinations of controllers and software.
Controller : RC700-A
Software : EPSON RC+ 7.0 Ver.7.3.4 or later
Setting by Software
EPSON
RC+
This manual contains setup procedures using the software.
Those sections are indicated by the symbol on the left.
Turning ON/OFF Controller
When you see the instruction “Turn ON/OFF the Controller” in this manual, be sure to
turn ON/OFF all the hardware components.
Photos and Illustrations Used in This Manual
The appearance of some parts may differ from those on an actual product depending on
when it was shipped or the specifications. The procedures themselves, however, are
accurate.