Epson N6 Series - Page 94

Setup & Operation 6. Options
82 N6 Rev.2
Precautions for use
CAUTION
■
If the
Manipulator is operated without connecting the brake release unit and the
external short connector, the brakes cannot be released and it may cause
damage on them. After using the brake release unit, be sure to
connect the
external short connector to the Manipulator, or check connection of the connector
for the brake release unit.
■
Keep the external short connector.
Otherwise you cannot release the brakes.
■
If you turn ON the brake release unit while the brake release switch is being
pressed, an unintended arm may move downward.
Before turning ON the brake release unit, make sure that the brake release
switch is not pressed.
■
If you turn ON the brake release unit without the connector, it may lead to the
short for the male pin used in the connector.
Before turning ON the brake release unit, make sure that the connector is
connected.