ETC Element 2 User Manual

Presets 297
In previous software releases, when content was released, it always returned to the last fader
that owned it. Background priority releases to the highest priority content that previously had
ownership, provided that content has not be turned off or released.
There are 10 levels of background priority for faders. 1 is the lowest and 10 is the highest.
When LTPcontent is released to background, it will go to the background state with the
highest available priority.
Up Time
This is the time for the fader to fade from its home position to its target position (0 to Full if
additive, Full to 0 if inhibitive). The default time is 0.
Dwell Time
This is the time the fader look will hold before starting the downfade. This can be set to a
specified time, or to “Hold” or “Manual”. “Hold” time maintains the fader values until the
bump is pressed a second time. “Manual” time applies the fader values only as long as the
bump is held. The default is “Manual”.
DownTime
This is the time for the content on a fader to fade from its target position to its home position.
The default time is 0.
Stomp Mode
Stomp happens when all the content owned by a fader is now being controlled by other
targets. The fader is being removed from the background , and once that happens, it would
not be eligible to fade back. You can assign behavior that will happen when a fader is
stomped.
•
Off When Stomped - puts the content into an off state, the same behavior encountered
when pressing [Off] + [Load].
•
Unload When Stomped - unloads the fader.
•
Nothing When Stomped - no action happens to the fader.
•
Release When Stomped -This function behaves the same as Off When Stomped.
Unmark at 0%
When this option is on, marked content controlled by the fader will automatically be released
when the fader reaches 0%. When the bump button is next pressed, the fader will fire. If this
option is off, you would need to first press the bump button to reset the fader before pressing
the bump again to fire it.
Note: This option is for faders that are set to Intensity Master.
Exclusions
Those exclusions include:
•
Exclude From Record - output is not recorded into any other record target.
•
Exclude From Grandmaster - content cannot be mastered by a grandmaster.
•
Exclude From Inhibitive Sub - content cannot be mastered by an inhibitive submaster
•
Exclude From Solo - content will ignore solo. See Fader and Button Configuration (on
page333) for more information on solo.

ETC Element 2 Specifications

General

DMX Outputs	2
Touchscreen	Yes
Networking	Ethernet
Type	Lighting Control Console
Master Faders	2
Encoders	4
Ethernet Ports	2
USB Ports	4
Video Output	DisplayPort
Power Input	100-240VAC, 50/60Hz
Power Supply	Internal
Control Channels	6144
Output	Art-Net
Display	Multi-Touch LCD
Storage	Solid State Drive (SSD)