Single Cue Lists 331
In Manual Master mode, cues are triggered manually by faders without using the [Go]
button. With a cue list on a fader set to manual master, a cue will fire in manual time
when the fader is moved from 0% or from Full. Timing is scaled. So, if color has a 5
count delay, and the duration of the cue is 10, the color transition will not begin until
the faders manually reach 50%. Follow and hang times will be ignored when firing a cue
with a manual master fader.
HTP
Intensity playback behavior can be set to HTP (highest takes precedence) or LTP (latest takes
precedence). For cues, it defaults to LTP.
Assert
Assert can be turned on or off at the fader level. This property sets the entire cue list to be
asserted on playback (even track instructions are replayed).
Priority
Priority is used to protect values from being affected by submasters or playback faders that
have a lower priority level. They will, however, still be impacted by manual control,
grandmaster, blackout, park instructions, or other playback faders and submasters at the same
or higher priority.
There are 10 levels of Priority that cue lists can have. 1 is the lowest level and 10 is the highest.
The default priority level is 4.
Background
Background can be enabled or disabled at the fader level. When enabled, the content of the
cue list will act as a background or previous state for other cues and submasters. When a cue
list has its background state disabled, a “D” will display in the Cue List Index background
column.
Background Priority
Background can have a priority assigned to it.
In previous software releases, when content was released, it always returned to the last fader
that owned it. Background priority releases to the highest priority content that previously had
ownership, provided that content has not be turned off or released.
There are 10 levels of background priority. 1 is the lowest level and 10 is the highest. The
default background priority level is 4.
Phantom
When a cue list is set to Phantom, pressing [Go] will not change the selected cue on the
command line, or an unlocked playback status display.
Back From First
Back From First controls the behavior that happens when you press the [Back] button while in
the first cue.
The following are Back From First options:
Do Nothing - keeps the first cue active.
Cue Out(Default Setting) - only fades out channels in that cue list. Other channels will
remain. Intensity and non-intensity parameters will be homed. This setting uses the Back
time for fading.
Wrap - puts the last cue in the list in pending, and fires said cue.
To Next Page
Loading...
Need help?
General
