426 Eos Apex, Eos Ti, Gio, Gio @5, Ion Xe, Ion Xe 20, and Element 2 User Manual
Note:
Changes may take a few seconds to make. They will propagate to the RDM
device and then back to the console’s patch and about displays.
Device Label (displayed at the top by the address number)
DMX Address (can be changed in this display by clicking on the property or value)
Note:
Changing the address can not cause any part of the fixture to move to a
different universe or communication with the device may be lost. The universe is set
into the gateways port configuration.
Note:
Details displayed will vary based on the device.
DMX Label (same as the device label, but the label can be changed here by clicking on
the property or value)
Type
Manufacturer
Device ID
Footprint
Version
Lamp State
Lamp Hours
Head DC Voltage
Lamp On/Off
Gel Distance Traveled
Gel2 Distance Traveled
Fan RPM
Ambient Temperature
Gel Temperature
Device Errors (will only display if there are current errors)
Clear Errors
Device Errors are displayed in four different colors depending on severity.
Note:
Color severity is determined by the device manufacturer.
Gray - unknown or not an error
White - Advisory
Yellow - Warning
Red - Error
[About] Cuelist
The following information will be displayed when a cue list is selected:
Cue List Attributes
Active Cue
The number of cues in the list (Multipart cues are only counted once)
First cue in the list
Last cue in the list
Partition
Playback number and physical fader location of the cue list
To Next Page
