ETC Element 2 - Page 439

Using About 425
•
Open issues list (if available)
•
Usage notes including switch settings and configuration (if available)
•
Alternate fixture names (if any)
{Lamp Controls} displays controls for the lamp or other parameters of the device (if it is an
automated fixture).
{Next/ Last Unpatched} will allow you to see what addresses closest to the current address are
currently unpatched.
{Dimmer Feedback} - appears when the current address is patched to a dimmer in an ETC
Sensor rack with a CEM+ or CEM3. Sensor feedback must be enabled. See Interface Protocols
(on page563) and Errors and Warnings (on page186) for more information.
Note: For Sensor feedback, the CEM+ must be running software version 3.0 or later.
{Dimmer Feedback} displays the following information:
•
Name (dimmer name)
•
Module type
•
Rack/Position
•
Rack dimmer level (displayed as a percentage)
•
Rack dimmer source
•
Recorded load
•
Actual load
{Dimmer Feedback} displays the following information, which can be modified by clicking on
the value and entering in a new value:
•
Firing Mode
•
Control Mode
•
Curve
•
Threshold
•
Scale Minimum
•
Scale Maximum
•
Preheat Enable
•
Preheat Timing
•
Advanced Features (AF) Enable
The following softkey commands are supported from this display:
•
{Ignore Errors}
•
{Clear Errors}
Note: Clearing CEM+ or CEM3 errors will be temporary unless the errors have been
fixed at the CEM+ or CEM3. Errors displayed will clear on their own once they have
been cleared from the CEM+ or CEM3. Some CEM+ or CEM3 errors can only be
cleared at the Sensor rack.
{Device Details} - appears when the current address is patched to a RDM device. RDM devices
must be enabled through the ECU and discovered through the patch. See RDM (on page564) ,
Patch Section (on page177) , and Errors and Warnings (on page186) .
{Device Details} displays the information that it receives from the device and allows some
changes to be made to: