564 Eos Apex, Eos Ti, Gio, Gio @5, Ion Xe, Ion Xe 20, and Element 2 User Manual
File Transfer
This settings adjusts the show file transfer speed between devices. The default setting is Fast
File Transfer.
Note:
If you are experiencing connection issues between devices, you can change
the setting to Normal File Transfer for a slower transfer speed.
Enable Sensor/ FDX3000 Feedback
Clicking in the enable box will allow your console to receive feedback over the network from
CEM+, CEM3, or FDX3000. This option is “Enabled” by default. See
[About] Address (on
page424)
for more information.
RDM
RDM can be enabled to allow Eos to perform RDM functionality including device discovery for
each ethernet port on a console. By default, RDMis enabled.
See
Patch Section (on page177)
and
[About] Address (on page424)
for more information.
Note:
RDM requires use of a Net3 or Response Gateway. Net3 Gateways must be
using version 5.1 or higher.
FDX2000 Feedback
Clicking in the enable box will allow your console to receive FDX2000 dimmer feedback over
the network.
WiFi Remote
Select to allow WiFi RFRs, like the iRFR or aRFR, to connect to Eos.
UDP Strings and UDPOSC
Clicking in the enable box will allow the selected port to send and receive UDP and OSC
strings.
TCP OSC
Clicking in the enable box will allow the selected port to send and receive OSC via TCP port
3032. Select the OSC TCP format. By default, OSC 1.0 is selected.
Note:
Check the documentation for the OSC device you wish to use over a TCP
connection to see which mode it supports.
OSC 1.0 (packet-length headers)
OSC 1.1 (SLIP)
Third Party OSC
Enables or disables dedicated server port 3037for use with third-party OSCapplications.
DHCP Service
Note:
All settings in this section require a reboot of the console before they will take
effect.
To Next Page
Loading...
