ETC Element 2 User Manual

Eos Configuration Utility 563
Net2-EDMX
This sets the control priority for EDMX data from this console. The valid range for this setting is
20 (lowest) to 1 (highest). This is the reverse of sACN.
AVAB UDP
This sets the subnet for AVAB UDP data from this console. The priority levels range from 0-
200. The default is 0, which is no priority level. 1 is the lowest priority level and 200 is the
highest. When set to no priority level (0), the data will merge according to HTP.
A backup console will receive its AVAB UDP priority level from the primary. The backup will
then output at one priority higher than the primary, unless the primary was set to the highest
priority of 200.
Art-Net
This sets the subnet for Art-Net data from this console. The valid Art-Net Start range for this
setting is 0-255.
Broadcast Type
•
Directed Broadcast - Broadcast packets are directed to a subnet based on the IP address
and subnet mask of the sender.
•
Limited Broadcast - The limited broadcast address is 255.255.255.255. It is limited
because routers will never forward datagrams with that destination address. This means
that datagrams with the limited broadcast address are confined to the particular
network segment on which they originate.
Backup Takes Over At Higher Priority
This enables the backup device in a multi-console system to take over at one priority higher
than the primary if the primary goes offline.
Backup Automatically Takes Control
Switches to the backup automatically if the primary should go offline.
Allowed Output Addresses
A range or ranges of addresses that can be assigned to limit the number of output addresses.
The default setting is to allow addresses 1 through 32767488.
Interface Protocols
MultiConsole
Clicking in the enable box will allow for multi-console communication on the selected port.
See Multi-Console (on page541) .
Network Type
This setting adjusts the timeout period before a backup device will take control from the
primary.
•
Standard- After five seconds of no response from the master, the backup will assume
the primary has disconnected and will then take control.
•
Engineered - After 1.6 seconds of no response from the primary, the backup will assume
the primary has disconnected and will then take control.

ETC Element 2 Specifications

General

DMX Outputs	2
Touchscreen	Yes
Networking	Ethernet
Type	Lighting Control Console
Master Faders	2
Encoders	4
Ethernet Ports	2
USB Ports	4
Video Output	DisplayPort
Power Input	100-240VAC, 50/60Hz
Power Supply	Internal
Control Channels	6144
Output	Art-Net
Display	Multi-Touch LCD
Storage	Solid State Drive (SSD)