ETC Element 2 - Page 631

Show Control 617
OSCSwitch
Note: Switch is a variant of Wheel with the added functionality of continuously
repeating wheel ticks until a subsequent OSC switch command sets the wheel ticks to
zero.This may be used to continuously tick a wheel while a button is held down, for
example. The expected argument range is -1.0 to 1.0, which affects the tick rate
accordingly, but can be a smaller or larger range for more subtle or rapid movement.
OSC Method Arguments Examples/Comments
Switch/Wheel Level
/eos/switch/level X level wheel ticks
/eos/switch Set OSC wheel mode 0 = Course, 1 = Fine
Switch Mode Output – see Implicit OSC Output (on page630) for more information
/eos/out/switch Current OSC wheel mode /eos/out/switch=1.0
Swich/Wheel and Encoder Levels
/eos/switch/<parameter>
X OSC wheel mode ticks for
specified parameter (ex: pan)
/eos/switch/<parameter 1>/
<parameter 2>/...
X OSC wheel mode ticks for
specified parameters (ex: red,
green, blue)
/eos/switch/fine/<parameter>
X fine wheel ticks for specified
parameter (ex: pan)
/eos/switch/fine/<parameter 1>/
<parameter 2>/...
X fine wheel mode ticks for
specified parameters (ex: red,
green, blue)
/eos/switch/course/<parameter>
X course wheel ticks for specified
parameter (ex: pan)
/eos/switch/course/<parameter
1>/
<parameter 2>/...
X course wheel mode ticks for
specified param- eters (ex: red,
green, blue)
OSCActive Parameters
Note: The parameter <index> is a 1-based index referencing the list of current
parameters for the selected channel(s).Eos will send the parameter name and current
value for each active parameter, so that the wheels on your OSC-enabled device may
be labeled appropriately.
OSC Method Arguments Examples/Comments
Wheel
/eos/active/wheel/<index>
number of wheel
ticks for the
specific wheel
mode (positive or
nega- tive)
/eos/active/wheel/1=1.0 (increase
value)
/eos/active/wheel/1=-1.0 (decrease
value)
/eos/active/wheel/1=4.0 (increase
value rapidly)
(defaults to Coarse mode, but wheel