3GS Technical Manual
Issue 4.5 August 2005
8-76 Programming Menus
• 1: Password access. Access code required before serial comms.
Note For Class IV systems, password protetction is compulsory on all remote communications.
• 2: Callback. Controller will hang-up after a valid connect sequence from the communications device and ring the pre-
programmed telephone number.
Autodial ID
This may be set as any number between 0-9999 and is recognised by communications software as a unique account
number for the installation.
Enter Dial Command
This is a set up command sent by the system to the modem before the modem dials out. The default command for the 3GS
Controller is:
AT E0 V1 Q0 D
Enter tel. No. 1
This is the number dialled by the system when contacting a remote location. This must not be left blank if dial mode is non-
zero.
If successful, communications cannot be established and a backup number will be dialled (see “Enter Tel. No. 2” on page
8-76).
Enter Tel. No. 2
This is the backup number which is dialled if connection is not established using the primary telephone number. This may
be left blank if a backup facility is not required.
To Next Page
Loading...
