Nodes 5-10
RKD Node with Optional Card Module
The remote keypad with in-built card module has the standard keypad functions and specifications with an additional
HID/proximity card reader, which allows the setting and unsetting of the system when a card is presented.
The connector blocks on the RKD with card module are removable, and the node features ferrite beads for improved
ringnet noise immunity.
햲
Remote Keypad PCB
햳
HID/Proximity Card Module
햴
PCB locating pillar
Programming Portable ACE Units Using RKD
You can access the Portable ACE unit through the keypad, and configure users for the card module. Portable ACE
functionality is also accessible through Panelman for Windows software.
Assigning Portable ACE Users
To program a Portable ACE user, you must select the RKD node on which the Portable ACE is installed. You then assign
users to this node by presenting valid proximity cards for each user. You should have valid proximity cards ready for
each of the users you wish to assign to this ACE Unit.
Note You must perform the programming at the RKD node on which the ACE unit is installed.
1
2
3
To Next Page
Loading...
