Extron electronics DMP 128 FlexPlus - Page 184

DMP 128 FlexPlus • Web Pages 175
NAT Traversal
1
NAT Traversal Configuration
5
TURN Port
2
STUN Server Address
6
TURN Username
3
STUN Port
7
TURN Password
4
TURN Server Address
8
Apply Button
Figure 201. VoIP Network NAT Traversal Page
1
NAT Traversal Configuration — From the drop-down, select Disabled (default),
STUN Server, TURN Server, or STUN/TURN (ICE) as the NAT traversal method used
by the system.
NOTE: When NAT Traversal is set to STUN/TURN (ICE), both STUN and TURN
fields can be completed. ICE then automatically determines the appropriate
method for traversal.
2
STUN Server Address — Specify the IP address or domain name of the STUN server
to be used.
3
STUN Port — Specify the port number of the STUN server.
4
TURN Server Address — Specify the IP address or domain name of the TURN server
to be used.
5
TURN Port — Specify the port number of the TURN server.
6
TURN Username (optional) — Enter the username for the TURN server, if one is
required.
7
TURN Password (optional) — Enter the password for the TURN server, if one is
required.
8
Apply Button — Click Apply to commit changes.
NOTE: When changes are committed with the Apply button, network services on
the DMP 128 FlexPlus restart. This process can take up to 30 seconds.
NOTE: For more information regarding VoIP network configuration, refer to the
DMP128FlexPlus product page on www.extron.com.
figure 191. NAT Traversal
PRELIMINARY
PRELIMINARY