FLIR Ranger HRC MS - Save; Open; Setup menu

Ranger HRC™ operator´s manual – IR Camera software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 91
8.3.2 File menu
Figure 8.3 File menu.
Menu choice Possible choices Explanation
Save – Press the ENTER button to save the current image
to the camera’s internal le system.
Open – Press the ENTER button to open an image from a
le list in the camera’s internal le system
Directories – Use the navigation pad to browse the directories in
the camera’s internal le system.
Delete image – Press the ENTER button to delete an image.
8.3.3 Setup menu
NOTE: The rst time you are entering the Setup menu, you have to enter an access code.
The default code is 0000. The code will prevent non-authorized personnel from changing
the camera settings. Enter the access code by using the arrow buttons. To change the
access code, see section 8.3.3.10 – Access cod
e.
Figure 8.4 Setup menu.