FLIR Ranger HRC MS - Advanced Procedures; Select Scene

Ranger HRC™ operator´s manual – Optimizing the IR Image
168 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Saving settings
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select IR menu from the Setup menu and press the ENTER button. The menu system
of the IR Camera is opened.
3 Select Setup and press the ENTER button.
4 Select Save settings and press the ENTER button. The Save settings dialog box is
displayed.
5 Select OK and press the ENTER button to conrm.
6 Press the CANCEL button to exit the IR Camera menu system.
12.2 Advanced procedures
This section describes how the advanced user can make use of automatic
and manual features and settings to optimize the image quality.
To avoid cross references, some of the descriptions and instructions in
this section are duplications of corresponding parts in the basic proce-
dures section.
For detailed information about the optimizing functions, please refer to
section 5.2.
For typical settings in low and high contrast scenes, please refer to section
12.3.
12.2.1 Select scene
The camera uses the scene as viewed on the monitor as basis for image
adjustments. The target scene, including zooming and focusing, shall be
selected before adjustments are made to optimize the image.