FLIR Ranger HRC MS - Adjustment area; Selecting adjustment area

Ranger HRC™ operator´s manual – Optimizing the IR Image
160 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
12.1.1.4 Adjustment area
The IR Camera automatically adjusts the image based on the scene con-
tents. By selecting different adjustment areas, it is possible to control
which part of the scene that shall be used when adjusting the image.
For basic optimization of the image, the camera shall be set to use the
largest adjustment area; Area 3.
Figure 12.4 Adjust Area 3.
Selecting adjustment area
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select IR menu from the Setup menu and press the ENTER button. The menu
system of the IR Camera is opened.
3 Select Setup and press the ENTER button.
4 Select Image… and press the ENTER button. The Image Setup dialog box is
displayed.
5 Select Adjust area.
6 Use the LEFT/RIGHT navigation buttons to select Area 3.
7 Press the ENTER button to conrm.
8 Press the CANCEL button to exit the IR Camera menu system.