Ranger HRC™ operator´s manual – System operation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 137
11.2 Basic features
Basic features can be executed with the JCU or via the System Software
menu system.
Basic features
Feature ORIGINAL setting ALTERNATIVE setting
TV/IR Press the TV/IR button to toggle between TV imaging and IR imaging.
FOV (alt. 1)
Press the joystick button < 1
second to
go to the next preset eld-of-view.
-
FOV (alt. 2) Press the ENTER button to enter MENU mode.
Select
FOV… from the Image menu and press the ENTER button to go to the next
preset eld-of-view.
Zoom Use the joystick to direct the camera towards the target scene.
Press the
button to zoom in.
Press the
button to zoom out.
Turn the joystick collar to the left to
zoom out.
Turn the joystick collar to the right to
zoom in.
Auto focus Verify that the target is in the center of the image.
Keep the camera steady when auto focusing.
Press the
NUC button > 1second to per-
form a one-shot auto focus adjustment.
Press the joystick button < 1 second
to perform a one-shot auto focus
adjustment.
NOTE: If the default setting for
the
NUC button has been changed
(Setup- Image dialog box, see sec-
tion 7.6.1.1), the
NUC button shall be
pressed < 1 second to auto focus.
The NUC button can also be used to
auto focus, as for the Original setting.
Auto focus
(TV only)
Ensure that TV is selected. If not, press the TV/IR button to select TV.
Press the ENTER button to enter MENU mode.
Select
Auto focus from the Image menu and press the ENTER button.
NOTE: The Auto focus feature is not supported by all TV cameras. If not
supported, the
Auto focus feature is disabled in the Image menu.
To Next Page
Loading...
