FLIR Ranger HRC MS - IR and TV Camera

Ranger HRC™ operator´s manual – Hardware installation
106 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Mounting the Pan/Tilt unit
Step Action
1 Position the Pan/Tilt unit on the JPC2 unit.
NOTE: The connector at the bottom of the Pan/Tilt must be on the same side as
the connectors on the JPC2 unit.
2 Tighten the four M8 x 20 screws, Figure 9.1, item (1).
9.1.3 IR and TV Camera
The Pan/Tilt unit is equipped with a left and a right mounting plate, whe-
re the IR and TV cameras are mounted. Seen from the front side, the IR
Camera shall be mounted on the left mounting plate; Figure 9.2, item 1);
and the TV Camera on the right mounting plate; Figure 9.2, item 2).
Figure 9.2 Mounting plate for the IR Camera (1) and the TV camera (2)
1 2