FLIR Ranger HRC MS - Focus; Manual Focus; Auto Focus

Ranger HRC™ operator´s manual – Optimizing the IR Image
188 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Selecting Filter type
Step Action
1 Select Setup/IR menu to open the IR Camera menu system.
2 Select Setup/Image…/Filter.
3 Use the LEFT/RIGHT navigation buttons to select Low, High or Off.
4 Press the ENTER button to conrm.
5 Press the CANCEL button to exit the IR Camera menu system.
12.3.2 Focus
Typical settings:
Low contrast Manual focus
Normal contrast Auto focus
High contrast Auto focus
12.3.2.1 Manual focus
Manual focusing
Step ORIGINAL setting ALTERNATIVE setting
1 Turn the joystick collar to the left/right to focus
near/far.
Press button FCN and turn the joystick
collar to the left/right to focus near/far.
12.3.2.2 Auto focus
Auto focusing
Step ORIGINAL setting ALTERNATIVE setting
1 Verify that the target is in the center of the image.
2 Keep the camera steady when auto focusing.
Press button
NUC > 1 second to perform
a one-shot auto focus adjustment.
Press the joystick button < 1 second to
perform a one-shot auto focus adjustment.
NOTE: If the default setting for the
NUC button has been changed (
Setup-
Image dialog box, see section 7.6.1.1),
the NUC button shall be pressed < 1
second to auto focus.
The NUC button can also be used to auto
focus, as for the Original setting.