FLIR Ranger HRC MS - Save Settings; Default Settings

Ranger HRC™ operator´s manual – Basic settings
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 133
Setting Slave mode On/Off
Step Description
1 Press the ENTER button to enter MENU mode.
2 a Select Slave mode On from the Image menu and press the ENTER button to activate
Slave mode.
2 b Select Slave mode Off from the Image menu and press the ENTER button to deactivate
Slave mode.
10.5 Save settings
When a setting is changed, it will apply as soon as the ENTER button is
pressed to conrm the change. To save the current settings for the next
time the system is started up, the PRK button has to be pressed.
Save settings
Step Action
1 Press the PRK button > 1 second to save the system settings. The system will be sent
to the mechanical home position.
NOTE: Do not turn off the system while “Saving” is displayed on the monitor.
10.6 Default settings
The Default setting feature is used to reset system settings to default values.
NOTE: Settings such as autoscan points and autoscan lists, Baudrate and Protocol are
not changed.
Setting default values
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select Maintenance …from the Setup menu and press the ENTER button. The Setup
– Maintenance dialog box is displayed.
3 Select Default settings.
4 Use the LEFT/RIGHT navigation buttons to select Yes.
5 Press the ENTER button to conrm and to exit MENU mode.