FLIR Ranger HRC MS - Autoscan Point Selection

Ranger HRC™ operator´s manual – Basic settings
128 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
10.2.4 Autoscan point selection
The Left/Right scanpoint selection feature is used to control the function
of the and buttons:
On: The and buttons are used to move the system to the pre-
vious/next autoscan point. This is the default setting.
Off: The and buttons can not be used to move the system to the
previous/next autoscan point.
Autoscan point selection setting
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select Pan-Tilt …from the Setup menu and press the ENTER button. The Setup – Pan/
Tilt dialog box is displayed.
3 Select Left-Right scanpoint selection.
4 Use the LEFT/RIGHT navigation buttons to select the desired NUC button setting; On
or Off.
5 Press the ENTER button to conrm and to exit MENU mode.