FLIR Ranger HRC MS - Pin Configuration - Joystick Control Unit (JCU); J10 - 23-Pin Connector

Ranger HRC™ operator´s manual – Technical appendices
204 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Pin Signal name Wire type
H TXPOS_HOSTUP AWG 26 twisted pair
J TXNEG_HOSTUP AWG 26 twisted pair
K Signal GND AWG 26 twisted pair
15.5.2 Pin conguration – Joystick Control Unit (JCU)
15.5.2.1 J10 – 23-pin connector
NOTE: Pin designations are printed on connector.
Pin Signal name Wire type
A Reserved
B Reserved
C TV Video negative Coax 75 Ω
D TV Video positive Coax 75 Ω
E Terminator disable AWG 26
F RS485CONSRX_A AWG 26 twisted pair
G RS485CONSRX_B AWG 26 twisted pair
H RS485CONSTX_A AWG 26 twisted pair
J RS485CONSTX_B AWG 26 twisted pair
K RS485HOSTRX_A AWG 26 twisted pair
L RS485HOSTRX_B AWG 26 twisted pair
M RS485HOSTTX_A AWG 26 twisted pair
N RS485HOSTTX_B AWG 26 twisted pair
P RS485TX_EN_A AWG 26 twisted pair
R RS485TX_EN_B AWG 26 twisted pair
S Video positive Coax 75 Ω
T Signal GND AWG 26
U Remote present AWG 26